Salsbury-industries 62000 Series Standard Lockers Double Tier User Manual download pdf

Standard Lockers – 62000 Series

Double Tier Installation Instructions

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering@lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Thank you for selecting Salsbury’s standard double tier lockers. These instructions are intended to assist you in assembling the lockers. Note that a 6 feet high locker is shown. Hole

locations on the 5 feet high locker are different. Assembly of the various locker components will be with #10 - 24 x 3/8” long slot less screws and #10 nuts (provided). Loosely fasten a

screw and a nut into every set of mating holes with the screw heads positioned on the outside of the locker or on the exposed surface.

One Wide Locker Assembly

Step 1: Attach the top shelf, bottom shelf, and two single coat hooks to the back

panel.

Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the

first side panel, the left rear leg, and one compartment divider to the assembly from

Step 1. Attach an additional two single coat hooks to the first side panel and a double

coat hook to the bottom of the top shelf and a second double coat hook to the bottom

of the compartment divider.

Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.

Attach an additional two single coat hooks to the second side panel. The locker

chassis is now complete.

Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.

Step 5: Tighten all fasteners checking for squareness of the locker while tightening.

Attach optional sloping hood, end bases or front base (see pages 4 and 5).

Step 6: Place the locker in the installed location and anchor to the floor, wall, or to

both. Individual job conditions will dictate the type of fastening anchors to use (not

provided).

Step 7: Fasten all lockers in a row together by installing fasteners provided through

the side panels. Installation is now complete.

1 2 3 4 5

SALSBURY INDUSTRIES 1