Salsbury-industries 4325D Designer Roadside Mailboxes Newspaper Holder User Manual download pdf

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-624-5269 Int’l Phone: 323-846-6700

Fax: 1-800-624-5299 Int’l Fax: 323-846-6800

www.mailboxes.com engineering

@mailboxes.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Designer Roadside Mailboxes – 4325D

Newspaper Holder on Pedestal Installation Instructions

U.S.P.S. APPROVED

Thank you for selecting Salsbury’s 4325D designer roadside mailbox. This instruction sheet is for installing the 4325D mailbox along with a 4315 newspaper holder

on a pedestal. Other installation instructions are available for installing the mailbox on a pedestal, or on a deluxe mailbox post, installing the mailbox on spreaders,

and installing the pedestal in a concrete footing.

When you install a curbside or roadside mailbox, make sure that it is easily accessible to the mail carrier. By regulation a locked mailbox should be 41” to 45” from

the ground or street surface up to the point of mail entry. The door should be set back 6” to 8” back from the front face of the curb or the road edge. However, you

should check with your local postmaster to ensure that the mailbox is installed according to local regulations. It is important to note that it is not the responsibility of

mail carriers to open mailboxes that are locked, accept keys for this purpose, or lock mailboxes after delivery of the mail.

Newspaper Holder to Pedestal Installation

Install four (4) 5/16”-18 x 2” long pan head bolts provided with the pedestal

through the four (4) square holes shown in the inside floor of the newspaper

holder and through the four (4) tapped holes on the top plate of the pedestal.

Insert a Phillips head screw driver through each square hole directly above,

and in the top of the newspaper holder, to tighten the pan head bolts.

Mailbox Installation on a Newspaper Holder and Pedestal

All hardware to attach the mailbox to the newspaper holder is included with

the newspaper holder. To attach the mailbox to the newspaper holder, unlock

and open the front door or rear door of the mailbox and install four (4) 5/16”-

18 X 3/4” long carriage bolts into (4) square holes in the floor of the mailbox

and through the four (4) square holes shown on the top of the newspaper

holder. Install 5/16” flat washers and 5/16”-18 hex nuts on the ends of the

four (4) bolts protruding below the top of the newspaper holder. Cover the

hex nuts with cap plugs. Installation is complete. Additional hardware

provided is not needed and may be discarded.

1 2 3 4 5